Tools Required: 1/2” socket wrench

Remove & discard packaging materials.

Flip all parts over so you can see the bottom side of the tabletop and fasteners on inside of leg assemblies. The inside of the table top and each leg assembly are marked with an “A” and a “B”, move legs to corresponding sides.

Note: the legs will not allow you to attach them to the incorrect side.

Remove the 4 nuts and washers on the inside of the tabletop on each side, and pull bolts partially out. You may need to use a wrench or other tool to remove them if the hole is very tight, but can typically slide them back with your hands. The nuts and washers toward the inside of the table (1 each per bolt) are only included for shipping and are no longer needed.

Insert leg into table top to corresponding side (A or B), with fasteners to the inside of the table.

Push bolts in as far as you can by hand, then finger-tighten until snug into fixed fastener.

Note: If bolts will not slide in without turning them, simply go as far as you can by hand and move to next step.

Turn all bolts until tight. The washer should ideally be slightly compressed into the wood, but be careful not to overtighten.

Flip over and enjoy!

Tools Required: 1/2” socket wrench

Remove & discard packaging materials.

Remove the 4 nuts and washers on the inside of the steps and pull bolts out. You may need to use a wrench or other tool to remove them if the hole is very tight, but can typically slide them back with your hands.

The nuts and washers toward the inside of the steps (1 each per bolt) are only included for shipping and are no longer needed.

Connect corresponding sides (A to A) and insert fastening bolts. Turn all bolts until tight. The washer should ideally be slightly compressed into the wood, but be careful not to overtighten.

Flip over and enjoy!